Return to the BUILD
“In the final stage for this pack, you’ll fit the bulkheads into place on the rear body of your model. You’ll also prepare the rear lights by fitting their reflectors into the housings. The parts supplied with this stage can be stored away until they are needed in the final pack.”
Contents
Parts
Materials: The non-electrical parts in this stage are plastic.
Build
The parts supplied in this stage will not be needed until the next pack arrives, so keep them stored somewhere safe for now:
Preparing the Rear Lights
Step 1
Retrieve your Left Brake Light Housing and Left Brake Light Reflector from Stage 89. Press the two tabs of the Reflector fully into the matching slots of the Housing, aligning the round holes as shown:
Retrieve your Right Brake Light Housing and Right Brake Light Reflector from the previous stage. Again, press the two tabs of the Reflector fully into the matching slots of the Housing, aligning the round holes as shown:
Installing the Body Bulkheads
Step 2
Retrieve your two Body Bulkheads from Stage 89. Note this small pin on each Bulkhead:
Retrieve your Rear Body assembly from the previous stage and place it upside down on a soft cloth. Then, starting with the Right Body Bulkhead, slide it into this location on in the interior of the Rear Body, as shown:
Make sure the small pin is seated in the hole at this location, as shown:
Secure this Body Bulkhead into place with one (1) Type A screw.
This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:
Step 3
In the same way, slide the Left Body Bulkhead into the same position on the opposite side of the Rear Body, again seating the pin in the appropriate hole:
Secure this Body Bulkhead into place with one (1) Type A screw:
Thoughts
This stage completes Pack 11 of the Agora Models release of the Miura. At this point, we should still have the Left Brake Light LED from Stage 89, as well as the Right Brake Light LED, Boot Lock, License Plate Lights, and License Plate Light Glass parts left over from Stage 90. Keep these (and the parts from this stage) stored safely until the final Pack arrives.
Next Up
Stage 92 – Boot Compartment/Profile, Rear Light Lenses, Reverse Light Glass/Support, Adhesive Cover